Level up your Game Gear experience with the custom-designed CleanAmp Duo by RetroSix! Crafted by DIY modding wizards, this ultra-efficient class D amplifier takes your audio to the next level.
Say goodbye to missing bass notes and high tones with the CleanAmp Duo. It's all about restoring that epic tonal range for an immersive gaming experience like never before. Plus, it's over 200% louder than the original – but it's not just about volume. Get ready to feel every low beat, every high treble, and every coin collect like it's your first time.
You can use the CleanAmp Duo both as a single (mono) output or stereo (duo) output. Connect just a single speaker to use it as a single speaker setup. Connect both speakers and bridge the STEREO solder pad (see product media) to enable dual output or leave it unsoldered for dual mono, with identical audio from both speakers.
INCLUDED:
- 1x CleanAmp Duo Board
- 2x 4 Ohm Speaker
- 1x Speaker Extension Wire
- 1x Speaker Mount Bracket
- 3x Screws
PAIRS WELL WITH:
DOCUMENTATION:
- - This video shows steps that are no longer needed. There is no need for an inductor swap and no need to swap audio and power cables.
NOTES:
- Some revisions will require soldering a wire to bridge the 5V from power connector over to 5V on audio connector. If your audio cuts out when high, you will need to perform this step. Use a 30AWG to 26AWG wire, 20cm.
- Created by .
